New features and fixes for CarPlay navigation on HUD & cluster, Android Auto and fault code diagnostics. Updates install automatically through the Wayglass Installer.
HUD & instrument cluster guidance (CarPlay 0.5.4 and Android Auto 0.3.31)
NewNew “Guidance test” button: for 30 seconds the HUD or instrument cluster shows a sample route with turns, a roundabout, lanes and a distance countdown. You can check that guidance works without starting a route on the phone.
RemovedLane guidance is always on and always drawn in perspective, like the BMW navigation. The lane options are gone from settings.
RemovedThe Wayglass screen in “My Vehicle” now starts with “Status”. The “Refresh” button is gone because the screen updates by itself, and the installed version is shown at the bottom.
RemovedThe “Where to show” screen is gone: where guidance appears now follows the HUD setting in iDrive. Cars with a screen instrument cluster and a HUD get a single “Show on HUD and cluster” checkbox.
Fixedguidance no longer disappears completely if “HUD” was chosen earlier on a car with an analog cluster or without a HUD.
FixedBMW G series: guidance no longer stays off after the car is switched on until Wayglass is restarted. A lost connection to the cluster is now shown on the Wayglass screen.
Android Auto 0.3.31
FixedAndroid Auto no longer gets stuck at “Connecting to Android Auto” until a head unit restart when the car’s Bluetooth forgets the Android Auto service.
FixedAndroid Auto now starts again when you leave the car and get back in right away.
FixedAndroid Auto no longer stops working when the phone reconnects at the very moment you leave the car, and it comes back faster after a short stop.
NewNew firmware: NBTevo_T20454I (Toyota Supra).
Diagnostics 0.1.1
ImprovedInstalls on every NBT Evo firmware Wayglass supports, including J16383I, O18184I, R19144I, S19322I, T20454I, U19384I, V20153J, W20204I and Y21272I.
Installing from a USB stick 0.5.10
ImprovedIf the head unit is not coded for apps (A4A_REMOTE_APPS = aktiv), installing from a USB stick refuses right away, and the log on the stick says what to code.