Activate Wired CarPlay or Android Auto on EntryNav2
Activate wired (USB) CarPlay or Android Auto on your EntryNav2 head unit yourself. Your code activates one feature, which you choose during installation.
Before you start
- A Windows PC — Windows 11 is recommended
- An ENET cable (Ethernet ↔ OBD) connected between the car and the PC
- A data USB cable for your phone
- Ignition on, engine off
- A stable internet connection on the PC
- A supported software version: O2014C1R, P2021B1R, Q2051B1R, R2124C1R, R2144B1R, U2324C1R or T2229C1R
-
Enter your licence key and validate it
Open the Infodem Installer, type the key you received with your purchase and validate it.
Download -
Choose CarPlay or Android Auto
Choose the feature you want. Each code activates one feature. If you want both, place a second order to receive another code.
-
Start the activation
Start the activation and wait until it ends, without switching off the ignition.
-
Restart the infotainment and connect your phone
Hold the power/volume button for about 30 seconds, until the screen turns off and on again. Then connect your phone over USB and unlock it.
Frequently asked questions
The car does not respond
Check that the ENET cable is firmly connected at both ends and that the ignition is on, wait one minute and try again.
My software version is not supported
Update your unit to a supported version before installation. Your code stays valid and you can use it after updating.
I want both CarPlay and Android Auto
Each code activates one feature. Place a second order to receive another code.